|
Forklifts HMT Series 1 are with load capacity from 1,6 to 2,5 tons at load center 500 mm
Chassis
The chassis of fabricated steel plate gives high strength and reliability of construction.
Uniform alignment of loading over entire construction
Lifting equipment
A robust produced mast of all roller construction affords immense strength, maximum load stability and mast rigidity at full lift height.
Excellent visibility
Full width load rollers and side thrust rollers between inner and outer mast ensure complete alignment and an even distribution of loading.
Engine
Modern 4 cylinders diesel engine Volkswagen – EURO3 or 4 cylinders petrol / LPG engine Volkswagen.
According to the last standards and requirements for exhaust emissions and noise level
High performance, long service period, low fuel consumption
Transmission
Heavy-duty industrial power shift transmission GRAZIANO for work in hard conditions, directly mounted to the engine.
Hydrodynamic transmission gives 1 forward and 1 reverse speeds. Gear selection is electrically controlled.
    Drive axle
The forklifts HMT have a heavy-duty double reduction type drive axle GRAZIANO with spiral bevel primary and hub planetary secondary.
Steering axle
Mounted to the chassis through special rubber pads
Double acting cylinder is fully protected from from mechanical damages
Hydraulic valves protected double acting cylinder from high overloading
Fully hydrostatic power steering is giving excellent maneuverability without operator fatigue.
Brakes
Brake cylinder provides light control and smooth operation.
Brake system is working with brake fluid.
Driver’s module
The drive’s module is mounted to the chassis on independence rubber pads.
A wide staircase gives good access to the driver’s position.
The truck is equipped with suspension seat, which is adjustable to ensure high level of driver comfort. The seat is with shock - absorber.
All meters and gauges are on the steering column.
Safety
Pressure relief valves in: brake pedal, hydrostatic power steering, control valves and other units.
Load lifting and lowering speed valve.
Load lowering valve in hoisting hydraulic plunger cylinders.
Tilt speed valve.
Fork movement speed and anti willfully movement of forks with load valve.
The forward / reverse lever do not give possibility to start the engine if is not in the neutral position.
Alarm signal for reverse movement.
Warning orange lamp.
Driver’s overhead guard answered of all requirements for safety work and gives possibility for good all round visibility.
Seat belts.
Optional Equipment
Air condition.
Spark arrestor and inlet flame trap.
All attachments for forklift trucks.
|
